Observium_CE/mibs/cisco/CISCO-IETF-VPLS-LDP-MIB

239 lines
7.2 KiB
Plaintext

-- *****************************************************************
-- CISCO-IETF-VPLS-LDP-MIB.my
--
-- November 2006, Mark Tooker
--
-- Copyright (c) 2006-2009 by cisco Systems, Inc.
-- All rights reserved.
-- *****************************************************************
CISCO-IETF-VPLS-LDP-MIB DEFINITIONS ::= BEGIN
IMPORTS
MODULE-IDENTITY,
OBJECT-TYPE,
Unsigned32
FROM SNMPv2-SMI
MODULE-COMPLIANCE,
OBJECT-GROUP
FROM SNMPv2-CONF
TruthValue
FROM SNMPv2-TC
VPNId
FROM VPN-TC-STD-MIB
cvplsConfigIndex,
cvplsPwBindIndex
FROM CISCO-IETF-VPLS-GENERIC-MIB
ciscoExperiment
FROM CISCO-SMI;
cvplsLdpMIB MODULE-IDENTITY
LAST-UPDATED "200711221200Z"
ORGANIZATION "Cisco Systems, Inc."
CONTACT-INFO
"Cisco Systems
Customer Service
Postal:
170 W Tasman Drive
San Jose, CA 95134
USA
Tel: +1 800 553-NETS
E-mail: cs-l2vpn@cisco.com"
DESCRIPTION
"This MIB module contains managed object definitions for
LDP signalled Virtual Private LAN Services as in
[L2VPN-VPLS-LDP]
This MIB module enables the use of any underlying Pseudo Wire
network.
This MIB is based on the following IETF document.
http://www1.tools.ietf.org/html/draft-nadeau-l2vpn-vpls-mib-03"
REVISION "200711221200Z"
DESCRIPTION
"Initial version of this MIB."
::= { ciscoExperiment 141 }
-- Top-level components of this MIB.
--
-- Tables, Scalars
cvplsLdpObjects OBJECT IDENTIFIER
::= { cvplsLdpMIB 1 }
-- Conformance
cvplsLdpConformance OBJECT IDENTIFIER
::= { cvplsLdpMIB 2 }
cvplsLdpConfigTable OBJECT-TYPE
SYNTAX SEQUENCE OF CvplsLdpConfigEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"This table specifies information for configuring
and monitoring LDP specific parameters for
Virtual Private Lan Services(VPLS)."
::= { cvplsLdpObjects 1 }
cvplsLdpConfigEntry OBJECT-TYPE
SYNTAX CvplsLdpConfigEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"A row in this table represents LDP specific information
for Virtual Private Lan Service(VPLS) in a packet network.
It is indexed by cvplsConfigIndex, which uniquely
identifies a single VPLS.
A row is automatically created when a VPLS service is
configured using LDP signalling.
None of the read-create objects values can be
changed when cvplsRowStatus is in the active(1)
state. Changes are allowed when the cvplsRowStatus
is in notInService(2) or notReady(3) states only.
If the operator need to change one of the values
for an active row the cvplsConfigRowStatus should be
first changed to notInService(2), the objects may
be changed now, and later to active(1) in order to
re-initiate the signaling process with the new
values in effect."
INDEX { cvplsConfigIndex }
::= { cvplsLdpConfigTable 1 }
CvplsLdpConfigEntry ::= SEQUENCE {
cvplsLdpConfigMacAddrWithdraw TruthValue
}
cvplsLdpConfigMacAddrWithdraw OBJECT-TYPE
SYNTAX TruthValue
MAX-ACCESS read-create
STATUS current
DESCRIPTION
"This object specifies if MAC address withdrawl is
enabled in this service. If this object is true then
Mac address withdrawl Learning is enabled. If false,
then Mac Learning is disabled."
DEFVAL { true }
::= { cvplsLdpConfigEntry 1 }
-- VPLS LDP PW Binding Table
cvplsLdpPwBindTable OBJECT-TYPE
SYNTAX SEQUENCE OF CvplsLdpPwBindEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"This table provides LDP specific information for
an association between a VPLS service and the
corresponding Pseudo Wires. A service can have more
than one Pseudo Wire association. Pseudo Wires are
defined in the cpwTable."
::= { cvplsLdpObjects 2 }
cvplsLdpPwBindEntry OBJECT-TYPE
SYNTAX CvplsLdpPwBindEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"Each row represents an association between a
VPLS instance and one or more Pseudo Wires
defined in the cpwTable. Each index is unique
in describing an entry in this table. However
both indexes are required to define the one
to many association of service to pseudowire.
An entry in this table is instantiated only when
LDP signalling is used to configure VPLS service.
Each entry in this table provides LDP specific
information for the VPlS represented by
cvplsConfigIndex."
INDEX {
cvplsConfigIndex,
cvplsPwBindIndex
}
::= { cvplsLdpPwBindTable 1 }
CvplsLdpPwBindEntry ::= SEQUENCE {
cvplsLdpPwBindMacAddressLimit Unsigned32
}
cvplsLdpPwBindMacAddressLimit OBJECT-TYPE
SYNTAX Unsigned32 (0..4294967295)
MAX-ACCESS read-create
STATUS current
DESCRIPTION
"The value of this object specifies the maximum number
of learned and static entries allowed in the
Forwarding database for this PW Binding. The value 0
means there is no limit for this PW Binding."
DEFVAL { 0 }
::= { cvplsLdpPwBindEntry 1 }
-- Compliance requirement for read-only implementations.
cvplsLdpCompliances OBJECT IDENTIFIER
::= { cvplsLdpConformance 1 }
cvplsLdpModuleFullCompliance MODULE-COMPLIANCE
STATUS current
DESCRIPTION
"Compliance requirement for implementations that
provide full support for CISCO-IETF-VPLS-LDP-MIB.
Such devices can then be monitored and configured using
this MIB module."
MODULE -- this module
MANDATORY-GROUPS { cvplsLdpGroup }
::= { cvplsLdpCompliances 1 }
cvplsLdpModuleReadOnlyCompliance MODULE-COMPLIANCE
STATUS current
DESCRIPTION
"Compliance requirement for implementations that only
provide read-only support for CISCO-IETF-VPLS-LDP-MIB.
Such devices can then be monitored but cannot be
configured using this MIB modules."
MODULE -- this module
MANDATORY-GROUPS { cvplsLdpGroup }
OBJECT cvplsLdpConfigMacAddrWithdraw
MIN-ACCESS read-only
DESCRIPTION
"Write access is not required."
OBJECT cvplsLdpPwBindMacAddressLimit
MIN-ACCESS read-only
DESCRIPTION
"Write access is not required."
::= { cvplsLdpCompliances 2 }
-- Units of conformance.
cvplsLdpGroups OBJECT IDENTIFIER
::= { cvplsLdpConformance 2 }
cvplsLdpGroup OBJECT-GROUP
OBJECTS {
cvplsLdpConfigMacAddrWithdraw,
cvplsLdpPwBindMacAddressLimit
}
STATUS current
DESCRIPTION
"The group of objects supporting
management of L2VPN VPLS services using LDP."
::= { cvplsLdpGroups 1 }
END