-- ***************************************************************** -- RDN-CABLE-TRAFFIC-MANAGEMENT-MIB.mib: -- Motorola BSR's Cable Traffic Management MIB -- -- Copyright (C) 2008 by Motorola, Inc. -- All rights reserved. -- ***************************************************************** RDN-CABLE-TRAFFIC-MANAGEMENT-MIB DEFINITIONS ::= BEGIN IMPORTS riverdelta FROM RDN-MIB NOTIFICATION-TYPE, MODULE-IDENTITY, OBJECT-TYPE, Integer32, Counter32 FROM SNMPv2-SMI MacAddress, DateAndTime, DisplayString, TruthValue FROM SNMPv2-TC InterfaceIndex FROM IF-MIB; rdnCableTrafficManagementMib MODULE-IDENTITY LAST-UPDATED "200809160000Z" -- September 16, 2008 ORGANIZATION "Motorola" CONTACT-INFO "Motorola Customer Service 101 Tournament Drive Horsham, PA 19044 US Tel: +1 888 944 4357 Int Tel: +1 215 323 0044 Fax: +1 215 323 1502 Email: CPSSupport@Motorola.com" DESCRIPTION "MIB module for Motorola Cable Traffic Policy. Copyright (C) 2008 by Motorola, Inc. All rights reserved." REVISION "200809160000Z" -- September 16, 2008 DESCRIPTION "Added Copyright Statement into MIB modules's description." REVISION "200802260000Z" -- February 26, 2008 DESCRIPTION "Initial Version. " ::= { riverdelta 10 } -- -- RDN Cable Traffic Management Scalar Group -- -- -- These parameters apply globally for each configured Cable Traffic -- Management (CTM). CTM controls are applied to either Downstream or -- Upstream service flows specified via configuration. -- rdnCtmScalar OBJECT IDENTIFIER ::= { rdnCableTrafficManagementMib 1 } rdnCtmEnforcedClear OBJECT-TYPE SYNTAX INTEGER { noAction (1), clear (2) } MAX-ACCESS read-write STATUS current DESCRIPTION "Clears all monitored traffic counts thereby ending any enforcement in effect." REFERENCE "Proprietary MIB, defined in CTM Product Functional Specification." DEFVAL { 1 } ::= { rdnCtmScalar 1 } rdnCtmEnforcedSince OBJECT-TYPE SYNTAX DateAndTime MAX-ACCESS read-only STATUS current DESCRIPTION "Time at which cable traffic enforcement history was last cleared via CLI command, 'clear cable traffic history' or by writing a '1' to the object rdnCtmClearHistory." REFERENCE "Proprietary MIB, defined in CTM Product Functional Specification." ::= { rdnCtmScalar 2 } rdnCtmClearHistory OBJECT-TYPE SYNTAX INTEGER { noAction (1), clear (2) } MAX-ACCESS read-write STATUS current DESCRIPTION "This object is always read as the value noAction(1). Writing the value clear(2) clears the history of last enforcement for each monitored service flow as reported in the object rdnCtmEnforcedLast and the 'LastEnforced' column of the output of the CLI command 'show cable subscriber-usage'." REFERENCE "Proprietary MIB, defined in CTM Product Functional Specification." DEFVAL { 1 } ::= { rdnCtmScalar 3 } -- -- CTM Summary Table -- Shows the sum of the traffic transferred for all service flows -- controlled by each cable traffic policy on a cable interface. -- rdnCtmSummaryTable OBJECT-TYPE SYNTAX SEQUENCE OF RdnCtmSummaryTableEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "Summarizes the operation of the cable traffic management feature. Each entry summarizes the operation of a single cable traffic policy on a single cable interface." REFERENCE "Proprietary MIB, defined in CTM Product Functional Specification." ::= { rdnCableTrafficManagementMib 2 } rdnCtmSummaryTableEntry OBJECT-TYPE SYNTAX RdnCtmSummaryTableEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "The entry indexes are ifindex, direction, and cable traffic policy name. The direction is included as an index in order to sort the entries by direction." INDEX { rdnCtmSummaryIfIndex, rdnCtmSummaryDirection, rdnCtmSummaryTrafficPolicy } ::= { rdnCtmSummaryTable 1 } RdnCtmSummaryTableEntry ::= SEQUENCE { rdnCtmSummaryIfIndex InterfaceIndex, rdnCtmSummaryDirection INTEGER, rdnCtmSummaryTrafficPolicy DisplayString, rdnCtmSummaryMonitoredCount Integer32, rdnCtmSummaryTotalFlows Integer32, rdnCtmSummaryEnforcedFlows Integer32 } rdnCtmSummaryIfIndex OBJECT-TYPE SYNTAX InterfaceIndex MAX-ACCESS not-accessible STATUS current DESCRIPTION "MAC Domain ifIndex." ::= { rdnCtmSummaryTableEntry 1 } rdnCtmSummaryDirection OBJECT-TYPE SYNTAX INTEGER { downstream (1), upstream (2) } MAX-ACCESS not-accessible STATUS current DESCRIPTION "Traffic direction." ::= { rdnCtmSummaryTableEntry 2 } rdnCtmSummaryTrafficPolicy OBJECT-TYPE SYNTAX DisplayString MAX-ACCESS not-accessible STATUS current DESCRIPTION "Name of the cable traffic policy." ::= { rdnCtmSummaryTableEntry 3 } rdnCtmSummaryMonitoredCount OBJECT-TYPE SYNTAX Integer32 MAX-ACCESS read-only STATUS current DESCRIPTION "The sum of the monitored counts for all flows controlled by the cable traffic policy on the interface of this entry." ::= { rdnCtmSummaryTableEntry 4 } rdnCtmSummaryTotalFlows OBJECT-TYPE SYNTAX Integer32 MAX-ACCESS read-only STATUS current DESCRIPTION "Total number of service flows controlled by the cable traffic policy on a cable interface (i.e. MAC domain)." ::= { rdnCtmSummaryTableEntry 5 } rdnCtmSummaryEnforcedFlows OBJECT-TYPE SYNTAX Integer32 MAX-ACCESS read-only STATUS current DESCRIPTION "Number of service flows currently exceeding their credit limit while controlled by the cable traffic policy on a cable interface (i.e. MAC domain)." ::= { rdnCtmSummaryTableEntry 6 } -- -- CTM Enforced Table -- -- The Cable Traffic Management Enforced Table describes the set of service -- flows which are being effected by the configured Cable Traffic Management. -- These service flows are temporarily experiencing a lower Max Rate since -- the last 'clear cable subscriber-usage' command. -- rdnCtmEnforcedTable OBJECT-TYPE SYNTAX SEQUENCE OF RdnCtmEnforcedTableEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "Table of service flows which have exceeded their credit limit and been enforced since the last clearing of cable traffic history. Cable traffic history is cleared with the CLI command 'clear cable traffic history' or by writing clear(1) to the object rdnCtmClearHistory. This table does not include entries for service flows with rate limits reduced due to bidirectional enforcement." REFERENCE "Proprietary MIB, as described in the CTM Product Functional Specification." ::= { rdnCableTrafficManagementMib 3 } rdnCtmEnforcedTableEntry OBJECT-TYPE SYNTAX RdnCtmEnforcedTableEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "Each entry corresponds to a single service flow which started enforcement due to exceeding its credit limit since the last clearing of cable traffic history." INDEX { rdnCtmEnforcedIfIndex, rdnCtmEnforcedDirection, rdnCtmEnforcedServiceFlowId } ::= { rdnCtmEnforcedTable 1 } RdnCtmEnforcedTableEntry ::= SEQUENCE { rdnCtmEnforcedIfIndex InterfaceIndex, rdnCtmEnforcedDirection INTEGER, rdnCtmEnforcedServiceFlowId Integer32, rdnCtmEnforcedCmMacAddr MacAddress, rdnCtmEnforcedTrafficPolicy DisplayString, rdnCtmEnforcedMonitoredCount Counter32, rdnCtmEnforcedLast OCTET STRING, rdnCtmEnforcedRemain OCTET STRING, rdnCtmEnforcedLimitRate INTEGER, rdnCtmEnforcedReason INTEGER, rdnCtmEnforcedMonitored TruthValue } rdnCtmEnforcedIfIndex OBJECT-TYPE SYNTAX InterfaceIndex MAX-ACCESS not-accessible STATUS current DESCRIPTION "The mac domain interface index that the service flow is admitted to." ::= { rdnCtmEnforcedTableEntry 1 } rdnCtmEnforcedDirection OBJECT-TYPE SYNTAX INTEGER { downstream (1), upstream (2) } MAX-ACCESS not-accessible STATUS current DESCRIPTION "Direction of service flow." ::= { rdnCtmEnforcedTableEntry 2 } rdnCtmEnforcedServiceFlowId OBJECT-TYPE SYNTAX Integer32 MAX-ACCESS not-accessible STATUS current DESCRIPTION "The service flow ID." ::= { rdnCtmEnforcedTableEntry 3 } rdnCtmEnforcedCmMacAddr OBJECT-TYPE SYNTAX MacAddress MAX-ACCESS read-only STATUS current DESCRIPTION "The mac Address of modem to which service flow belongs." ::= { rdnCtmEnforcedTableEntry 4 } rdnCtmEnforcedTrafficPolicy OBJECT-TYPE SYNTAX DisplayString MAX-ACCESS read-only STATUS current DESCRIPTION "The cable traffic policy which service flow is controlled by." ::= { rdnCtmEnforcedTableEntry 5 } rdnCtmEnforcedMonitoredCount OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "For 'continuous' monitored policies, represents the excess traffic beyond the enforce rate for this service flow. For 'peak-interval' monitoring, represents the total traffic transferred in the curent or last completed peak-time interval. Units are kilobytes, with 1024 bytes per kilobyte." ::= { rdnCtmEnforcedTableEntry 6 } rdnCtmEnforcedLast OBJECT-TYPE SYNTAX OCTET STRING MAX-ACCESS read-only STATUS current DESCRIPTION "The amount of time since the service flow was last enforced. This field will be empty if it has not been enforced since the last time cable traffic history was cleared or since system start." ::= { rdnCtmEnforcedTableEntry 7 } rdnCtmEnforcedRemain OBJECT-TYPE SYNTAX OCTET STRING MAX-ACCESS read-only STATUS current DESCRIPTION "The minimum amount of time a service flow is to remain under enforcement." ::= { rdnCtmEnforcedTableEntry 8 } rdnCtmEnforcedLimitRate OBJECT-TYPE SYNTAX INTEGER MAX-ACCESS read-only STATUS current DESCRIPTION "The current scheduler limit rate for the service flow in kbps. This is either the configured maximum rate or the policy's enforce rate if flow is currently under enforcement. Units are kilobits per second, with 1000 bits per kilobit." ::= { rdnCtmEnforcedTableEntry 9 } rdnCtmEnforcedReason OBJECT-TYPE SYNTAX INTEGER { configured (1), bidirectional (2), enforced (3) } MAX-ACCESS read-only STATUS current DESCRIPTION "Indicates if the service flow's rate limit is currently reduced due to the cable traffic management feature. The value of configured(1) indicates the service flow is not reduced by the feature, i.e. it is limited to its configured maximum rate. The value of bidirectional(2) is reserved for future use. The rdnCtmEnforcedTable does not include flows reduced due to bidirectional enforcement. The value of enforced(3) indicates a service flow is currently enforced, i.e. it has over-consumed its monitored traffic credit limit." ::= { rdnCtmEnforcedTableEntry 10 } rdnCtmEnforcedMonitored OBJECT-TYPE SYNTAX TruthValue MAX-ACCESS read-only STATUS current DESCRIPTION "Indiacates if the service flow is currently being monitored, either true(1) or false(2)." ::= { rdnCtmEnforcedTableEntry 11 } END