ELTEX-L2-TUNNEL-CONFIG-MIB DEFINITIONS ::= BEGIN IMPORTS eltexLtd FROM ELTEX-SMI-ACTUAL MODULE-IDENTITY, OBJECT-TYPE, NOTIFICATION-TYPE, Unsigned32, Counter32 FROM SNMPv2-SMI MODULE-COMPLIANCE, OBJECT-GROUP, NOTIFICATION-GROUP FROM SNMPv2-CONF TruthValue, MacAddress FROM SNMPv2-TC ifIndex FROM IF-MIB QosLayer2Cos FROM CISCO-QOS-PIB-MIB; eltexL2TunnelConfig MODULE-IDENTITY LAST-UPDATED "201509080000Z" ORGANIZATION "Eltex Enterprise Co, Ltd." CONTACT-INFO "www.eltex.nsk.ru" DESCRIPTION "This MIB module is for layer 2 tunneling related configurations on a device. Tunneling allows separate local networks to be considered as a single VLAN. These separate networks are connected via an ISP, which will tunnel the packets from one network to another, making it appear as if the two networks are actually just one." ::= { eltexLtd 37 } eltexLtcMIBObjects OBJECT IDENTIFIER ::= { eltexL2TunnelConfig 1 } eltexLtcGlobal OBJECT IDENTIFIER ::= { eltexLtcMIBObjects 1 } eltexLtcTunneledProtocol OBJECT IDENTIFIER ::= { eltexLtcMIBObjects 2 } eltexLtcTunnelThreshold OBJECT IDENTIFIER ::= { eltexLtcMIBObjects 3 } eltexLtcTunnelStatistics OBJECT IDENTIFIER ::= { eltexLtcMIBObjects 4 } -- -------------------- -- -- Textual Conventions -- -- -------------------- -- EltexLtcTunneledProtocolIndex ::= TEXTUAL-CONVENTION STATUS current DESCRIPTION "A tunneled protocol of an interface." SYNTAX INTEGER { stp(1), eth-fc(2), lacp(3), lldp(4), isis-l1(5), isis-l2(6), pvst(7), cdp(8), dtp(9), vtp(10), pagp(11), udld(12), rip(13), ospf(14), vrrp(15) } -- ------------------------ -- -- eltexLtcNotificationEnable -- -- ------------------------ -- eltexLtcNotificationEnable OBJECT-TYPE SYNTAX TruthValue MAX-ACCESS read-write STATUS current DESCRIPTION "This object indicates whether the system will generate the eltexLtcTunnelDropThresholdExceeded and eltexLtcTunnelShutdownThresholdExceeded notifications." ::= { eltexLtcGlobal 1 } -- ---------------- -- -- eltexLtcMacAddress -- -- ---------------- -- eltexLtcTunnelMacAddress OBJECT-TYPE SYNTAX MacAddress MAX-ACCESS read-write STATUS current DESCRIPTION "The destination MAC address that replaces the original destination MAC address of tunneled frames." DEFVAL { '0100EEEE0000'H } ::= { eltexLtcGlobal 2 } -- ---------------------------- -- -- eltexLtcTunneledProtocolTable -- -- ---------------------------- -- eltexLtcTunneledProtocolTable OBJECT-TYPE SYNTAX SEQUENCE OF EltexLtcTunneledProtocolEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "This table contains information about the protocols being tunneled. Only tunneled protocol filtering capable interfaces are shown." ::= { eltexLtcTunneledProtocol 1 } eltexLtcTunneledProtocolEntry OBJECT-TYPE SYNTAX EltexLtcTunneledProtocolEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "Information about the protocols being tunneled. Only tunneled protocol filtering capable interfaces are shown." INDEX { ifIndex } ::= { eltexLtcTunneledProtocolTable 1 } EltexLtcTunneledProtocolEntry ::= SEQUENCE { eltexLtcTunneledProtocolType BITS, eltexLtcTunnelCos QosLayer2Cos } eltexLtcTunneledProtocolType OBJECT-TYPE SYNTAX BITS { stp(0), eth-fc(1), lacp(2), lldp(3), isis-l1(4), isis-l2(5), pvst(6), cdp(7), dtp(8), vtp(9), pagp(10), udld(11), rip(12), ospf(13), vrrp(14) } MAX-ACCESS read-write STATUS current DESCRIPTION "Indicates tunneled protocol of the interface. If a BIT is set, then the value of the corresponding protocol is tunneled. Specifically, if the 'stp(0)' BIT is set, then the Spanning Tree Protocol PDU is tunneled. At this moment, there are no other supported protocols. If the bit for a given protocol is set for an interface, then the statistics for that interface and protocol will start to be monitored." ::= { eltexLtcTunneledProtocolEntry 1 } eltexLtcTunnelCos OBJECT-TYPE SYNTAX QosLayer2Cos MAX-ACCESS read-write STATUS current DEFVAL { 5 } DESCRIPTION "Specifies the user priority of the tunneled PDUs for the interface." ::= { eltexLtcTunneledProtocolEntry 2 } -- -------------------------- -- -- eltexLtcTunnelThresholdTable -- -- -------------------------- -- eltexLtcTunnelThresholdTable OBJECT-TYPE SYNTAX SEQUENCE OF EltexLtcTunnelThresholdEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "This table contains information about the thresholds for protocol tunneling. Only tunneled protocol filtering capable interfaces are shown. The objects will be on a per interface, per protocol basis." ::= { eltexLtcTunnelThreshold 1 } eltexLtcTunnelThresholdEntry OBJECT-TYPE SYNTAX EltexLtcTunnelThresholdEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "Information about the thresholds for protocol tunneling. Only tunneled protocol filtering capable interfaces are shown. The entries will be on a per interface, per protocol basis" INDEX { ifIndex, eltexLtcTunnelThresholdProtocolIndex } ::= { eltexLtcTunnelThresholdTable 1 } EltexLtcTunnelThresholdEntry ::= SEQUENCE { eltexLtcTunnelThresholdProtocolIndex EltexLtcTunneledProtocolIndex, eltexLtcTunnelDropThreshold Unsigned32, eltexLtcTunnelShutdownThreshold Unsigned32 } eltexLtcTunnelThresholdProtocolIndex OBJECT-TYPE SYNTAX EltexLtcTunneledProtocolIndex MAX-ACCESS not-accessible STATUS current DESCRIPTION "A tunneled protocol of an interface." ::= { eltexLtcTunnelThresholdEntry 1 } eltexLtcTunnelDropThreshold OBJECT-TYPE SYNTAX Unsigned32 UNITS "PDUs/sec" MAX-ACCESS read-write STATUS current DESCRIPTION "The drop threshold on an interface for a given protocol. After reaching this drop threshold, the interface will start dropping PDUs for the given protocol. This value cannot be greater than the value of eltexLtcTunnelShutdownThreshold. A value of 0 indicates that no limit is set." DEFVAL { 0 } ::= { eltexLtcTunnelThresholdEntry 2 } eltexLtcTunnelShutdownThreshold OBJECT-TYPE SYNTAX Unsigned32 UNITS "PDUs/sec" MAX-ACCESS read-write STATUS current DESCRIPTION "The shutdown threshold on an interface for a given protocol. After reaching the shutdown threshold, the interface will shutdown for the given protocol. This value cannot be less than the value of eltexLtcTunnelDropThreshold. A value of 0 indicates that no limit is set." DEFVAL { 0 } ::= { eltexLtcTunnelThresholdEntry 3 } -- ---------------------------- -- -- eltexLtcTunnelStatisticsTable -- -- ---------------------------- -- eltexLtcTunnelStatisticsTable OBJECT-TYPE SYNTAX SEQUENCE OF EltexLtcTunnelStatisticsEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "This table contains protocol tunneling statistics on the interface." ::= { eltexLtcTunnelStatistics 1 } eltexLtcTunnelStatisticsEntry OBJECT-TYPE SYNTAX EltexLtcTunnelStatisticsEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "Protocol tunneling statistics on the interface." INDEX { ifIndex, eltexLtcTunneledProtocolIndex } ::= { eltexLtcTunnelStatisticsTable 1 } EltexLtcTunnelStatisticsEntry ::= SEQUENCE { eltexLtcTunneledProtocolIndex EltexLtcTunneledProtocolIndex, eltexLtcTunnelEncapStats Counter32, eltexLtcTunnelDecapStats Counter32, eltexLtcTunnelDropStats Counter32 } eltexLtcTunneledProtocolIndex OBJECT-TYPE SYNTAX EltexLtcTunneledProtocolIndex MAX-ACCESS not-accessible STATUS current DESCRIPTION "A tunneled protocol of an interface." ::= { eltexLtcTunnelStatisticsEntry 1 } eltexLtcTunnelEncapStats OBJECT-TYPE SYNTAX Counter32 UNITS "encapsulated PDUs" MAX-ACCESS read-only STATUS current DESCRIPTION "The tunneled PDU encapsulation statistics of an interface. These statistics cover the number of tunneled ingress PDUs." ::= { eltexLtcTunnelStatisticsEntry 2 } eltexLtcTunnelDecapStats OBJECT-TYPE SYNTAX Counter32 UNITS "de-encapsulated PDUs" MAX-ACCESS read-only STATUS current DESCRIPTION "The tunneled PDU de-encapsulation statistics of an interface. These statistics cover the number of tunneled egress PDUs." ::= { eltexLtcTunnelStatisticsEntry 3 } eltexLtcTunnelDropStats OBJECT-TYPE SYNTAX Counter32 UNITS "PDUs" MAX-ACCESS read-only STATUS current DESCRIPTION "The number of PDUs dropped on an interface for a given protocol. The PDUs will be dropped when the eltexLtcTunnelDropThreshold is reached." ::= { eltexLtcTunnelStatisticsEntry 4 } -- ------------- -- -- Notifications -- -- ------------- -- eltexLtcMIBNotifications OBJECT IDENTIFIER ::= { eltexL2TunnelConfig 2 } eltexLtcMIBNotificationsPrefix OBJECT IDENTIFIER ::= { eltexLtcMIBNotifications 0 } eltexLtcTunnelDropThresholdExceeded NOTIFICATION-TYPE OBJECTS { eltexLtcTunnelDropThreshold } STATUS current DESCRIPTION "This notification is generated when the eltexLtcTunnelDropThreshold has been exceeded." ::= { eltexLtcMIBNotificationsPrefix 1 } eltexLtcTunnelShutdownThresholdExceeded NOTIFICATION-TYPE OBJECTS { eltexLtcTunnelShutdownThreshold } STATUS current DESCRIPTION "This notification is generated when the eltexLtcTunnelShutdownThreshold has been exceeded." ::= { eltexLtcMIBNotificationsPrefix 2 } END