CADANT-OSPF-MIB DEFINITIONS ::= BEGIN

IMPORTS
    MODULE-IDENTITY, OBJECT-TYPE, Counter32,
    Gauge32,Integer32, IpAddress                 FROM SNMPv2-SMI
    TEXTUAL-CONVENTION, TruthValue, RowStatus    FROM SNMPv2-TC
    MODULE-COMPLIANCE, OBJECT-GROUP              FROM SNMPv2-CONF
    AreaID, RouterID, Metric, BigMetric, Status,
    PositiveInteger, HelloRange, UpToMaxAge,
    DesignatedRouterPriority, TOSType            FROM OSPF-MIB
    InterfaceIndexOrZero                         FROM IF-MIB
    cadLayer3                                    FROM CADANT-PRODUCTS-MIB
    cadVrIndex                                   FROM CADANT-VIRTUAL-ROUTER-MIB;

--  This MIB module uses the extended OBJECT-TYPE macro as
--  defined in [9].

cadOspf MODULE-IDENTITY
    LAST-UPDATED "200411180000Z"
    ORGANIZATION "Arris International"
    CONTACT-INFO
        "       Support
        Postal: Arris International
                4343 Commerce Ct.
                Lisle, IL 60532
        Tel:    +1 630 281 3200
        E-Mail: support@arrisi.com"

    DESCRIPTION
        "The MIB module to control and report on the Cadant Virtual Router
         implementation of the OSPF Version 2 Protocol. This MIB mirrors
         draft-ietf-ospf-mib-update-05."
    REVISION "200303010000Z"
    DESCRIPTION
      "Updated for latest changes to OSPF Version 2"
    REVISION "200306250000Z"
    DESCRIPTION
      "Updated default value of PE router"
    REVISION "200402130000Z"
    DESCRIPTION
      "Updated for OSPF Gracefule Restart"
    REVISION "200404120000Z"
    DESCRIPTION
	"Update some of the default values for graceful restart"
    REVISION "200406300000Z"
    DESCRIPTION
	"Change default value for Grace period"
    REVISION "200411180000Z"
    DESCRIPTION
	"Remove MIB objects that have been replaced by DCL MIB"
    ::= { cadLayer3 5 }



--  OSPF Use of the CIDR Route Table

cadOspfRouteGroup           OBJECT IDENTIFIER ::= { cadOspf 13 }

-- The IP Forwarding Table defines a number of objects for use by
-- the routing protocol to externalize its information.  Most of
-- the variables (ipForwardDest, ipForwardMask, ipForwardPolicy,
-- ipForwardNextHop, ipForwardIfIndex, ipForwardType,
-- ipForwardProto, ipForwardAge, and ipForwardNextHopAS) are
-- defined there.

-- Those that leave some discretion are defined here.

-- ipCidrRouteProto is, of course, cadOspf (13).

-- ipCidrRouteAge is the time since the route was first calculated,
-- as opposed to the time since the last SPF run.

-- ipCidrRouteInfo is an OBJECT IDENTIFIER for use by the routing
-- protocol.  The following values shall be found there depending
-- on the way the route was calculated.

cadOspfIntraArea      OBJECT IDENTIFIER ::= { cadOspfRouteGroup 1 }
cadOspfInterArea      OBJECT IDENTIFIER ::= { cadOspfRouteGroup 2 }
cadOspfExternalType1  OBJECT IDENTIFIER ::= { cadOspfRouteGroup 3 }
cadOspfExternalType2  OBJECT IDENTIFIER ::= { cadOspfRouteGroup 4 }

-- ipCidrRouteMetric1 is, by definition, the primary routing
-- metric.  Therefore, it should be the metric that route
-- selection is based on.  For intra-area and inter-area routes,
-- it is an OSPF metric.  For External Type 1 (comparable value)
-- routes, it is an OSPF metric plus the External Metric.  For
-- external Type 2 (non-comparable value) routes, it is the
-- external metric.

-- ipCidrRouteMetric2 is, by definition, a secondary routing
-- metric.  Therefore, it should be the metric that breaks a tie
-- among routes having equal metric1 values and the same
-- calculation rule.  For intra-area, inter-area routes, and
-- External Type 1 (comparable value) routes, it is unused.  For
-- external Type 2 (non-comparable value) routes, it is the metric
-- to the AS border router.

-- ipCidrRouteMetric3, ipCidrRouteMetric4, and ipCidrRouteMetric5 are
-- unused.

------------------------------------------------------------------------
-- cadOspfNetworkEnableTable 
-- This table is used so that the config information can be persistant
--
cadOspfNetworkEnableTable OBJECT-TYPE
    SYNTAX      SEQUENCE OF CadOspfNetworkEnableEntry
    MAX-ACCESS  not-accessible
    STATUS      current
    DESCRIPTION
           ""
    ::= { cadOspf 20 }

cadOspfNetworkEnableEntry OBJECT-TYPE
    SYNTAX      CadOspfNetworkEnableEntry
    MAX-ACCESS  not-accessible
    STATUS      current
    DESCRIPTION
           ""
    INDEX { cadVrIndex, cadOspfNetworkEnableIpaddress, cadOspfNetworkEnableWildcard }
    ::= { cadOspfNetworkEnableTable  1 }

CadOspfNetworkEnableEntry ::=
    SEQUENCE {
        cadOspfNetworkEnableIpaddress           IpAddress,
        cadOspfNetworkEnableWildcard        	IpAddress,
        cadOspfNetworkEnableAreaId      	AreaID,
        cadOspfNetworkEnableRowStatus      	RowStatus
    }

cadOspfNetworkEnableIpaddress OBJECT-TYPE
    SYNTAX      IpAddress
    MAX-ACCESS  read-only
    STATUS      current
    DESCRIPTION
           ""
    REFERENCE
          ""
    ::= { cadOspfNetworkEnableEntry 1 }

cadOspfNetworkEnableWildcard OBJECT-TYPE
    SYNTAX      IpAddress
    MAX-ACCESS  read-only
    STATUS      current
    DESCRIPTION
           ""
    REFERENCE
          ""
    ::= { cadOspfNetworkEnableEntry 2 }

cadOspfNetworkEnableAreaId OBJECT-TYPE
    SYNTAX      AreaID
    MAX-ACCESS  read-create
    STATUS      current
    DESCRIPTION
           ""
    REFERENCE
          ""
    ::= { cadOspfNetworkEnableEntry 3 }

cadOspfNetworkEnableRowStatus OBJECT-TYPE
    SYNTAX      RowStatus
    MAX-ACCESS  read-create
    STATUS      current
    DESCRIPTION
           ""
    REFERENCE
          ""
    ::= { cadOspfNetworkEnableEntry 4 }

-- conformance information

cadOspfConformance OBJECT IDENTIFIER ::= { cadOspf 15 }

cadOspfGroups      OBJECT IDENTIFIER ::= { cadOspfConformance 1 }
cadOspfCompliances OBJECT IDENTIFIER ::= { cadOspfConformance 2 }

-- compliance statements

-- units of conformance

END