initial commit; version 22.5.12042
This commit is contained in:
240
mibs/cisco/CISCO-MGX82XX-CARD-FEATURE-MIB
Normal file
240
mibs/cisco/CISCO-MGX82XX-CARD-FEATURE-MIB
Normal file
@ -0,0 +1,240 @@
|
||||
-- *****************************************************************
|
||||
-- ciscoMgx82xxCardFeatureMIB
|
||||
--
|
||||
-- May 2003, Subra Hegde
|
||||
--
|
||||
-- Copyright (c) 2003 by cisco Systems, Inc.
|
||||
-- All rights reserved.
|
||||
-- ****************************************************************
|
||||
|
||||
CISCO-MGX82XX-CARD-FEATURE-MIB DEFINITIONS ::= BEGIN
|
||||
IMPORTS
|
||||
MODULE-IDENTITY,
|
||||
OBJECT-TYPE,
|
||||
Integer32
|
||||
FROM SNMPv2-SMI
|
||||
MODULE-COMPLIANCE,
|
||||
OBJECT-GROUP FROM SNMPv2-CONF
|
||||
cardSpecific FROM BASIS-MIB
|
||||
ciscoWan FROM CISCOWAN-SMI;
|
||||
|
||||
ciscoMgx82xxCardFeatureMIB MODULE-IDENTITY
|
||||
LAST-UPDATED "200305050000Z"
|
||||
ORGANIZATION "Cisco Systems, Inc."
|
||||
CONTACT-INFO
|
||||
" Cisco Systems
|
||||
Customer Service
|
||||
|
||||
Postal: 170 W Tasman Drive
|
||||
San Jose, CA 95134
|
||||
USA
|
||||
|
||||
Tel: +1 800 553-NETS
|
||||
|
||||
E-mail: cs-wanatm@cisco.com"
|
||||
DESCRIPTION
|
||||
"The MIB module which describes the features
|
||||
supported in MGX82XX products.
|
||||
This MIB Module provides the features supported
|
||||
in Controller Cards in MGX8250 and MGX8220.
|
||||
|
||||
Terminologies used:
|
||||
|
||||
PXM : Processor Switch Module. This is controller
|
||||
card in MGX8250.
|
||||
ASC : AXIS Shelf Controller. This is controller
|
||||
card in MGX8220.
|
||||
VSI : Virtual Switch Interface, a hardware-independent
|
||||
switch control protocol. This allows a Switch to be
|
||||
controlled by a multiple controllers such as PNNI, MPLS.
|
||||
These control planes can be internal or external to the
|
||||
switch.The VSI interface defines the messages and associated
|
||||
functions which allow communication between the controller
|
||||
and the switch.This interface is expected to support all
|
||||
types of connections (voice,data,frame relay,ATM) for PVCs,
|
||||
SPVCs and SVCs.
|
||||
|
||||
Controller - Software ( and possibly hardware) which manages
|
||||
topology and network resources and performs VSI
|
||||
Master function. This performs source routing
|
||||
for end-to-end SVCs, including general call
|
||||
acceptance GCAC,setup calls with other controllers.
|
||||
PNNI and MPLS are examples of controllers."
|
||||
|
||||
REVISION "200305050000Z"
|
||||
DESCRIPTION
|
||||
"Initial version of the MIB.
|
||||
|
||||
The content of this MIB was originally available
|
||||
in CISCO-WAN-AXIPOP-MIB defined using SMIv1.
|
||||
The applicable objects from CISCO-WAN-AXIPOP-MIB
|
||||
are defined using SMIv2 in this MIB. Also the
|
||||
descriptions of some of the objects have been
|
||||
modified."
|
||||
::= { ciscoWan 74 }
|
||||
|
||||
ascFeatures OBJECT IDENTIFIER ::= { cardSpecific 5 }
|
||||
pxmFeatures OBJECT IDENTIFIER ::= { cardSpecific 15 }
|
||||
coreCardCommands OBJECT IDENTIFIER ::= { cardSpecific 20 }
|
||||
|
||||
vsiControllersAllowed OBJECT-TYPE
|
||||
SYNTAX Integer32 (0..16777215)
|
||||
MAX-ACCESS read-only
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"This respesents bit map of the VSI Controllers
|
||||
supported.
|
||||
The bit positions are :
|
||||
|
||||
BIT 0 - PAR(Portable AutoRoute Controller)
|
||||
BIT 1 - PNNI(Private network to network Interface)
|
||||
BIT 2 - TAG(Tag Switching or MPLS Controller)
|
||||
(e.g. A value of 1 in BIT 0 indicates the presence of PAR )
|
||||
Remaining bits are set to 0."
|
||||
::= { pxmFeatures 1 }
|
||||
|
||||
apsCardAttributes OBJECT-TYPE
|
||||
SYNTAX Integer32 (0..255)
|
||||
MAX-ACCESS read-only
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"This respesents bit map of the APS card attributes
|
||||
supported.
|
||||
The bit position supported are:
|
||||
BITs 0, 1 - unused
|
||||
BIT 2 - APS standard protocol configured
|
||||
(1 = TRUE ; 0 = FALSE)
|
||||
BIT 3, 4 ,5 - unused
|
||||
BIT 6 - Card HW supports APS 1+1 on two cards
|
||||
(1 = TRUE ; 0 = FALSE)
|
||||
BIT 7 - Card FW supports APS
|
||||
(1 = TRUE ; 0 = FALSE)
|
||||
Remaining bits are set to 0."
|
||||
::= { pxmFeatures 2 }
|
||||
|
||||
trkCACEnable OBJECT-TYPE
|
||||
SYNTAX INTEGER {
|
||||
disable (1),
|
||||
enable (2)
|
||||
}
|
||||
MAX-ACCESS read-write
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"This MIB variable allows to add a new connection on
|
||||
the feeder trunk even if it is over-subscribed."
|
||||
DEFVAL { disable }
|
||||
::= { pxmFeatures 3 }
|
||||
|
||||
pxmCardCacMode OBJECT-TYPE
|
||||
SYNTAX INTEGER {
|
||||
pcrBasedCac (1),
|
||||
scrBasedCac (2)
|
||||
}
|
||||
MAX-ACCESS read-write
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"This object identifies the CAC mode set on a card.
|
||||
|
||||
If this is set to pcrBasedCAC(1) then the CAC calculations
|
||||
will be done based on PCR on the connection.
|
||||
|
||||
If this set to scrBasedCAC(2) then the CAC calculations
|
||||
are done based on the scr of the connections.
|
||||
This will be applicable only if CAC is enabled
|
||||
(i.e trkCACEnable is set to enable(2))."
|
||||
DEFVAL { pcrBasedCac }
|
||||
::= { pxmFeatures 4 }
|
||||
|
||||
redundancyAllowed OBJECT-TYPE
|
||||
SYNTAX INTEGER {
|
||||
redNotAllowed (1),
|
||||
redAllowed (2)
|
||||
}
|
||||
MAX-ACCESS read-only
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"This object identifies whether redundancy
|
||||
is allowed in MGX82XX shelf."
|
||||
::= { ascFeatures 1 }
|
||||
|
||||
switchCoreCard OBJECT-TYPE
|
||||
SYNTAX INTEGER {
|
||||
noAction (1),
|
||||
doswitchcc (2),
|
||||
instswitchcc (3),
|
||||
fallbackswitchcc (4)
|
||||
}
|
||||
MAX-ACCESS read-write
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"This object is used for performing switchover of
|
||||
core card set. The core card set includes Controller Card
|
||||
and Service Redundancy Module(SRM).
|
||||
|
||||
The possible values are :
|
||||
noAction (1): No operation
|
||||
doswitchcc (2): Perform switchover operation
|
||||
instswitchcc (3): Perform switchover operation
|
||||
fallbackswitchcc(4): "
|
||||
::= { coreCardCommands 1 }
|
||||
|
||||
-- conformance information
|
||||
|
||||
cmCardFeatureMIBConformance OBJECT IDENTIFIER ::=
|
||||
{ ciscoMgx82xxCardFeatureMIB 2 }
|
||||
|
||||
cmCardFeatureMIBGroups OBJECT IDENTIFIER ::=
|
||||
{ cmCardFeatureMIBConformance 1 }
|
||||
|
||||
cmCardFeatureMIBCompliances OBJECT IDENTIFIER ::=
|
||||
{ cmCardFeatureMIBConformance 2 }
|
||||
|
||||
-- compliance statements
|
||||
|
||||
cmCardFeatureCompliance MODULE-COMPLIANCE
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"The compliance statement for objects related
|
||||
to Frame Relay Ports."
|
||||
MODULE -- this module
|
||||
MANDATORY-GROUPS {
|
||||
cmPxmCardFeatureGroup,
|
||||
cmAscCardFeatureGroup,
|
||||
cmCoreCardFeatureGroup
|
||||
}
|
||||
::= { cmCardFeatureMIBCompliances 1 }
|
||||
|
||||
cmPxmCardFeatureGroup OBJECT-GROUP
|
||||
OBJECTS {
|
||||
vsiControllersAllowed,
|
||||
apsCardAttributes,
|
||||
trkCACEnable,
|
||||
pxmCardCacMode
|
||||
}
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"The collection of objects which are used to represent
|
||||
Processor Module(PXM) Features."
|
||||
::= { cmCardFeatureMIBGroups 1 }
|
||||
|
||||
cmAscCardFeatureGroup OBJECT-GROUP
|
||||
OBJECTS {
|
||||
redundancyAllowed
|
||||
}
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"The collection of objects which are used to represent
|
||||
Axis Shelf Controller(ASC) Features."
|
||||
::= { cmCardFeatureMIBGroups 2 }
|
||||
|
||||
cmCoreCardFeatureGroup OBJECT-GROUP
|
||||
OBJECTS {
|
||||
switchCoreCard
|
||||
}
|
||||
STATUS current
|
||||
DESCRIPTION
|
||||
"The collection of objects which are used to represent
|
||||
core card related objects."
|
||||
::= { cmCardFeatureMIBGroups 3 }
|
||||
|
||||
END
|
||||
Reference in New Issue
Block a user